Manufacturer Home Hud tags, labels, serial numbers and data plates | Mobile Home Living (2023)

FAQs

What does the data plate on a manufactured home look like? ›

What is a Data Plate? The Data Plate is a paper label affixed inside the home and is the size of a standard sheet of paper (8 ½” x 11”). The Data Plate can be found in a kitchen cabinet, an electrical panel, or a bedroom closet.

Your manufactured or mobile home VIN number is typically found: On the data plate inside your home. Marked on your mobile home's steel frame (stamped into the steel cross member where the hitch is attached to for each section of the home)

The label number shall be etched or stamped with a 3 letter designation which identifies the production inspection primary inspection agency and which the Secretary shall assign. Each label shall be marked with a 6 digit number which the label supplier shall furnish.

The HUD tag is a 2 inch by 4 inch red metal plate riveted to the exterior wall of each section of mobile home.

Your mobile home VIN number is often found: On the data plate inside your home. Stamped on your mobile home's steel frame.

Modular homes are transported to the site in sections and are NOT dependent on I- beams, which are typically removed after delivery. Floor joists with and, they support the units permanently and cannot be removed. If you see metal beams, it is likely a MANUFACTURED HOME.

The Department of Housing and Urban Development (HUD) requires that a manufacturer place a large information sticker, called a “data plate,” on the interior of every mobile home manufactured since June 15th, 1976—and that's where you find out.

All manufactured homes and buildings will have a serial number and label permanently affixed verifying compliance with the applicable federal or state codes. Licensees should look for this compliance label and serial number.

A mobile or manufactured home will have 2 main identifiers: a HUD tag and a data plate. The HUD tag has the certification label on it and the data plate has both the serial number and the code certification number on it. The data plate is a white piece of paper usually found on the back side of a kitchen cabinet door.

Do manufactured homes have VIN numbers? ›

VIN stands for Vehicle Identification Number. It is essentially an ID that's given to your mobile home. The VIN provides information about your property's make and model and is unique to each that you may own. The VIN has several digits that can be decoded when you take a closer look at it.

That's because nearly all mortgage lenders require the manufactured homes they finance to meet HUD safety standards that were enacted on June 15th, 1976. HUD tags certify that the home meets those standards and data plates (also known as compliance certificates) list out all of the details of the manufactured home.

The HUD Code, unlike conventional building codes, requires manufactured homes to be constructed on a permanent chassis. Modular homes are constructed to the same state, local or regional building codes as site-built homes.

The model name/number is on the data plate inside the home. A HUD data plate has been required to be placed inside every mobile home manufactured since July, 1976, and it is usually located on the inside of a kitchen cabinet door, behind the door over the electrical panel, or on the wall of a closet.

The California Department of Housing and Community Development (HCD) insignia is required on mobilehomes, commercial modulars, and special purpose commercial modulars. The U.S. Department of Housing and Urban Development (HUD) label is required on manufactured homes.

The HCD insignia(s) or HUD label(s) is required to be located on the rear exterior wall at the lower left corner of the unit or on the exterior wall immediately adjacent to the main door.

The model number represents a specific type of machine made by a manufacturer while the serial number is specific to your machine.

Just like any other 17-digit VIN number, the last 6 positions (12-17) are the trailer's serial number. The serial number is what makes each VIN unique, since the VIN pattern or squish (positions 1-8, 10, and 11) will be the same, for the most part, for multiple VINs representing the same trailer model in a given year.

A recorded “Notice of Installation” aka 433A is the recognized California stamp of approval for a permanent foundation. Beyond proof of a permanent foundation, the 433A is also a title conversion document, verifying that the home and land are conjoined as real property.

The main difference between stick built home vs modular is how they are built. A modular home is built off-site and assembled on the property, while a stick-built home is completed constructed in one place.

What is the life expectancy of a manufactured home? ›

A report done by the Manufactured Housing Institute placed the average life expectancy of a manufactured home at 55.8 years (mhvillage.com). With the proper upkeep and maintenance, manufactured homes have a long-life expectancy, with the potential to last forever.

Prefab is a general term used for a prefabricated building or building component that is manufactured in a factory prior to its final assembly at the construction site, whereas modular refers to something built or organized in self-contained units—like building blocks.

A modular home is a house that's partially constructed in a factory and shipped to the homeowner's lot, where it's pieced together, put on a foundation and then completed. Like traditional homes, modular homes are placed on a permanent foundation and often have full basements.

The main difference lies in the base of both these homes. Usually, double-wide homes are built on a trailer, whereas modular homes are built on a dedicated foundation. So, unlike double-wide homes, modular homes aren't fully built off-site. Some of their components are constructed on-site.

Your decal number. The decal is a small metal plate that is usually attached to the outside of the home. The decal number is listed on the plate and has three letters and four numbers. (You will be asked to include this decal number on all of your Fee and Tax Waiver program application forms.)

Without a large pool of cheap used repos, people looking to purchase used homes are having to pay more for them. Retailers who buy used homes are also having to pay more for them. Not only do you have a low supply of used homes on the market today, you have the accelerated costs of new manufactured homes.

What if a Label or Data Plate Is Missing? Unfortunately, HUD does not reissue labels for manufactured houses. However, lenders can obtain verification letters with the same information from HUD's contractor, the Institute for Building Technology and Safety (IBTS).

No, a modular home will not have that familiar red HUD tag on the exterior wall, like the one shown above. Modular homes are not built under HUD supervision like a manufactured/mobile home. They are constructed to meet the local building code for their location, the same as a site-built single family home.

• The 433 A provides this department (HCD) notification from the local agency. issuing the installation permit that a manufactured home or commercial. modular structure has been installed on a foundation system on private. property and has been approved for occupancy.

Overview. An approval (silver) label will only be applied where no other approval process is available. An approval (silver) label will only be applied under a permit.

What is a data plate performance certificate? ›

The Data Plate/Performance Certificate provides following information*: Serial number (no VIN will be recorded in the certification) Date of manufacture. Name of the manufacturer and plant location. Wind zone, roof load zone and thermal zone.

The VIN number tells you when and where the car was built. It tells you the manufacturer, year, make and model, and the trim level including unique features and specifications. Your car's VIN number can be used to track recalls, registrations, warranty claims, thefts and insurance coverage.

The 10th character in the 17-character VIN represents the vehicle model-year. This standard applies to vehicles built in or after 1981. Before 1981, the VIN format was not standardized and varied by manufacturer.

Also called HUD tag numbers, are affixed to each transportable section of the home. There's one number for a single-wide, two for a double-wide.

The HUD-1 Settlement Statement is a document that lists all charges and credits to the buyer and to the seller in a real estate settlement, or all the charges in a mortgage refinance. If you applied for a mortgage on or before October 3, 2015, or if you are applying for a reverse mortgage, you receive a HUD-1.

HUD. U.S. Department of Housing and Urban Development.

The pier and beam system is the most popular foundation type for manufactured homes. With it, anchors are driven into the ground to hold the home down and protect it against wind. Then, steel straps connect the anchors to a main beam of the home's steel frame.

Most permanent modular buildings can last 35 years, 50 years or even centuries given the care and building type.

The data plate has a map of the United States to let the consumer know the Wind Zone, Snow Load, and Roof Load for which their home was built. You may request a Letter of Label Verification from the Institute for Building Technology and Safety (IBTS).

How many numbers are in a serial number for a mobile home? ›

Identification number- This set of 6 numbers that represent the home's serial number. Section code- This letter informs you if the mobile home has more than one section. Single-wide houses with just one section do not have a section code. Sections are specified as A or B to represent double-wide and triple-wide homes.

Some of the downsides of manufactured homes are the following; Value May Depreciate. Reselling may be difficult. Financing can be complicated.

Where to find your mobile home VIN. Your mobile home VIN number is often found: On the data plate inside your home. Stamped on your mobile home's steel frame.

An “uninsurable property” can mean one of two things: The home is not in good enough condition to qualify for FHA mortgage insurance (and thereby for an FHA loan). The home is ineligible for property insurance because the insurance company considers the home too great a risk to insure.

What information is on a forklift data plate? Sometimes referred to as a capacity plate or a forklift nameplate, the forklift data plate includes important information such as weight, fuel type, and forklift load capacity.

Data plates are identification tags that are found in a wide variety of industries. Regardless of the industry you are in, you may find that there is a need for durable metal plates. These plates can be used to outline instructions, indicate potential hazards, or showcase other key information.

That's because nearly all mortgage lenders require the manufactured homes they finance to meet HUD safety standards that were enacted on June 15th, 1976. HUD tags certify that the home meets those standards and data plates (also known as compliance certificates) list out all of the details of the manufactured home.

MODULAR HOME - If the home is a modular built after 1971, it should have a tag called a "Factory Built Unit Certification" attached. This certifies that it has been built to the requirements of the Universal Building Code (UBC), which is the same requirement of stick-built homes.

The rated capacity plate must be fitted, it must be secure, clear and legible and display, at least, the maximum weight the lift truck can pick up, the load centre and the maximum lift height, appropriate to the lift truck and or any attachments fitted.

The nameplate contains information about the construction characteristics and performance of the motor. The types of information that are shown include the number of phases, rated operating voltage, service duty, efficiency code, frame size, IP rating, insulation class and more.

What 4 checks must you make to a load before picking it up? ›